Mapping Call-Control Properties To Sip Headers; Mapping Call-Control Properties To Sip Headers Diagram - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Procedure: To define a phone context for the SIP interface
Mode: Interface SIP
Step
1
node (if-sip)[ if-name ]#phone-context
Example: Configure a phone-context
The following example shows how to configure a phone-context named mycompany for the SIP interface
MySipIf.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface sip MySipIf
node(if-sip)[MySipIf]#phone-context mycompany
Using the configuration of this example, the URIs build by the SmartNode look as follows:
sip:+41318432343@mysipdomain.com;user=phone
sip:531@mysipdomain.com;user=phone;phone-context=mycompany
sipbob@mysipdomain.com
Without the special configuration of this example, these URIs would look as follows:
sip:+41318432343@mysipdomain.com;user=phone
sip:531@mysipdomain.com
sipbob@mysipdomain.com

Mapping call-control properties to SIP headers

The command
address-translation
ties to SIP headers for outbound SIP calls and it allows also to map SIP headers to call-control properties for SIP
inbound calls (see figure
Figure 56. Mapping call-control properties to SIP headers diagram
SIP interface configuration task list
Command
in the interface sip configuration mode allows to map call-control proper-
56).
Outbound SIP calls map call-control properties
Inbound SIP calls map SIP headers
Outbound SIP calls
Call-control
properties
Inbound SIP calls
33 • SIP interface configuration
Purpose
Specify a phone context for the interface
SIP headers
call-control properties
SIP headers
384