Configure The Ip Address - Patton electronics DiamondLink 3201 Quick Start Manual

Terminal
block
(-) Terminal
(+) Terminal
1.2 Models with external DC power supply
1. Strip insulation 1/4-inch from the electrical wires that will connect the DC power source to the 48VDC
power supply terminal block (see
Connect the negative (-) terminal from the power source with to the negative (-) terminal on
2.
the power supply.
Connect the positive (+) terminal from the power source with to the positive (+) terminal on
3.
the power supply
Connect the 48VDC output barrel-type plug to the Power connector on the DiamondLink.
4.
1.3 Power-up indication
The Power LED blinks as the DiamondLink is powering up. When the Power LED stops blinking and remains lit,
the DiamondLink is ready for you to configure.
The DiamondLink is shipped with a factory-configured IP address assigned to the Ethernet LAN port (green out-
line). The address is 192.168.200.10/24. In most cases, you must change the address to be on the same subnet
as your PC, as described in the procedures below. If you are not sure which IP address to use for your installa-
tion, contact your network administrator.
DiamondLink 3201 & 3241 Quick Start Guide
Figure 1.
figure

2.0 Configure the IP address

48VDC power supply
1).
3