Configure Ip Address; Power Connection And Default Configuration; Connect With The Serial Interface; Connecting To The Terminal - Patton electronics IPLink 2821 Getting Started Manual

IPLink 2800 Series Getting Started Guide
1. Configure IP address
Power connection and default configuration
First the IPLink VPN Router must be connected to the mains power supply with the power cable. Wait until
Run
the LED stops blinking and lights constantly. Now the IPLink VPN Router is ready.
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
Table 9. Factory default IP address and network mask configuration
Interface Ethernet 0/0 (ETH0)
Interface Ethernet 0/1 (ETH1)
Interface Ethernet 0/2 (ETH2)
Interface Ethernet 0/3 (ETH3)
Interface Ethernet 0/4 (ETH4)
All Ethernet interfaces are activated upon power-up.
If these addresses match with those of your network, go to section
network" on page 44. Otherwise, refer to the following sections to change the addresses and network masks.

Connect with the serial interface

The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see
figure 10) between the IPLink VPN Router's Console port and a PC or workstation's RS-232 serial interface.
Activate the terminal emulation program on the PC or workstation that supports the serial interface (e.g.
HyperTerm).
Terminal emulation program settings:
• 9600 bps
• no parity
• 8 bit

1. Configure IP address

3 • Getting started with the IPLink Managed VPN Router
IP Address
172.16.40.1
192.168.1.1
e r
u t
R o
P N
k V
L i n
I P
o le
n s
C o
1
e t
E n
0
e t
E n
Figure 10. Connecting to the terminal
x.x.x.x
x.x.x.x
x.x.x.x
"2. Connect the IPLink VPN Router to the
Note A Patton Model 16F-561 RJ45 to DB-9 adapter is included with
each IPLink 2800 Series device
table
Network Mask
255.255.0.0
255.255.255.0
x.x.x.x
x.x.x.x
x.x.x.x
Serial Terminal
9.
42