Setting The Ip Address - Patton electronics IPLink 2884 Quick Start Manual

2.1 Default IP configuration
The factory default IP settings are as follows:
LAN port (ETH 0): IP address: 192.168.200.10, Netmask: 255.255.255.0, DHCP client
•
If this address conflicts or does not match with your network, it must be changed.
2.2 Connecting to the PC and logging in via the Ethernet port
1. To access the IPLink configuration, connect a PC's Ethernet port to the IPLink's LAN port (see
Use the black Ethernet cable included with your IPLink for this purpose.
0 / 3
0 / 2
0 / 1
1
0 / 0
/ E
T 1
Connect to Ethernet LAN
A
, 1
H z
r / 6 0
w e
P o 5 0
V ,
4 0
- 2
2 0
~ 1 ports, ETH 0 and ETH 1
2. Configure your PC's Ethernet port to be on the same subnet as the IPLink.
Open a Telnet connection to the default LAN IP address of the IPLink ( 192.168.200.10 ).
3.
Log into the unit using the following:
login: admin
password:
4

2.0 Setting the IP address

o le
n s
C o
0 / 1
3 2
- 2
H
E T R S
0 / 0
H
E T
IPLink 2884/2888
192.168.200.10
Figure 3. Connecting to the PC's ENET port
Figure
PC
Ethernet port
IPLink 2884/2888 Quick Start Guide
3).