Configure Ip Address; Power Connection And Default Configuration; Connect With The Serial Interface - Patton electronics SMARTNODE 4110 Series User Manual

SmartNode 4520 & 4110 Series User Manual

1. Configure IP address

CAUTION

Power connection and default configuration

First the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run'
LED stops blinking and lights constantly. Now the SmartNode is ready.
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
Table 8. Factory default IP address and network mask configuration
Interface Ethernet 0 (ETH0)
Interface Ethernet 1 (ETH1)
Both Ethernet interfaces are activated upon power-up.
If these addresses match with those of your network, go to section
on page 42. Otherwise, refer to the following sections to change the addresses and network masks.

Connect with the serial interface

The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see
figure 25) between the SmartNode's Console port and a PC or workstation's RS-232 serial interface. Activate the
terminal emulation program on the PC or workstation that supports the serial interface (e.g. HyperTerm).
Terminal emulation program settings:
• 9600 bp
• no parity

1. Configure IP address

The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
IP Address
192.168.1.1
e r
u t
R o
e
a y v i c
t e w
D e
G a
s s
I P c e
V o A c
4
e d
5 2
a t
e 4 g r
t e
o d
I n
o le
I P
t N n s
T o
a r C o
S m
r ts
P o
ic e
V o
1
e t
E n
0
e t
E n
Figure 25. Connecting to the terminal
4 • Getting started with the SmartNode
DHCP
"2. Connect the SmartNode to the network"
table
Network Mask
DHCP
255.255.255.0
8.
40