Connecting The Power Supply; Internal S-Bus Power Supply; Power Led (Smartnode 4638 Shown) - Patton electronics 4630 Series Getting Started Manual

SmartNode 4630 Getting Started Guide

Connecting the power supply

Do the following to connect the main power to the Model 4630:
Note
Do not connect the power cord to the AC power outlet at this time.
1. Insert the female end of the AC power to the mains port (see
CAUTION
2. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to "Contacting Patton for assistance"
power cord.
3. Connect the male end of the AC power cord to an appropriate AC power outlet.
Power
4. Verify that the green Power LED is lit (see

Internal S-Bus power supply

The Model 4630 supplies S-Bus line power on the BRI ports that can be activated individually for each port. If
a port is switched to TE mode, line power is switched off. A total of 4W are available.
Congratulations, you have finished installing the SmartNode Gateway Router! Now go to chapter 4,
configuration" on page 27.
Installing the gateway router
The internal power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
on page 33 to find out how to replace it with a compatible
Figure 6. Power LED (SmartNode 4638 shown)
figure
figure 2 on page 15).
6).
3 • SmartNode installation
"Initial
26