Direct Transmission; Manual Number Dialing (Direct Transmission) - Panasonic DP-2000 Operating Instructions Manual

Sending Documents

Direct Transmission

If your machine's memory is full or you wish to send the document immediately, use Direct Transmission.

Manual Number Dialing (Direct Transmission)

To dial the telephone number manually, follow the steps below.
Make sure that the FAX lamp is ON. If not, press
1
a
1
b
2
Make sure that the lamp goes off.
3
Enter a telephone number from the keypad.
Ex:
5 5 5 1 2 3 4
4
Your machine starts to dial the telephone number.
(see Note 1) (see Note 2) (see Note 3)
NOTE
1. If you need a special access number to get an outside line, dial it first then press
(represented by a "-") before dialing the full number.
Ex
: 9 PAUSE 5551234
2. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing, press
TONE
(represented by a "/").
The dialing mode will be changed from Pulse to Tone after dialing the digit "/".
Ex
: 9 PAUSE TONE 5551234
3. To stop the transmission, press
The display shows:
COMMUNICATION STOP?
1:YES 2:NO
1
Press to stop the transmission. The Communication Journal will not print out regardless of the printout mode
setting of the Communication Journal.
4. This field (Auto, Line-1 or Line-2) appears only when the 2nd G3 Fax Communication Port Option is installed.
Place original(s) face up on the ADF.
or
Place a book or an original face down on the
Platen Glass.
(see Note 4)
STOP .
BASIC OPERATIONS
to select the "FAX MODE".
ENTER STATION(S)
THEN PRESS START 00%
ENTER STATION
THEN PRESS START 00%
TEL NO.
5551234
* DIALING *
5551234
Note4
AUTO
PAUSE to enter a pause
49