Panasonic DP-2000 Operating Instructions Manual page 33

Customizing Your Machine
No. Parameter
013
AUTO JOURNAL PRINT
014 FILE ACCEPTANCE
REPORT
017
RECEIVE MODE
022
SUBSTITUTE RCV
024 PRINT REDUCTION
025
REDUCTION RATIO
026
POLLING PASSWORD
027
POLLED FILE SAVE
028
STAMP AT MEM. XMT
031
INCOMPLETE FILE
SAVE
033
XMT REDUCTION
036
RING PATTERN
DETECT (DRD)
(See Note 2)
037
RCV TO MEMORY
038 ACCESS CODE
Continued on the next page...
Setting
Setting
Number
1 Invalid Selecting whether the machine prints the journal automatically
after every 100 transactions.
*2 Valid
*1 Invalid Selecting whether the machine prints the file acceptance journal.
If you set this parameter to valid, a report will print after the
2 Valid
document is stored into memory.
1 Manual Setting the reception mode to automatic or manual.
*2 Auto
1 Invalid Selecting whether the machine receives to memory when the
recording paper runs out, toner runs out or the recording paper is
*2 Valid jammed.
1 Fixed Selecting the print reduction mode.
Fixed: Reduce received document according to setting of
*2 Auto
Auto: Reduce received document according to the length of
70 70% Selecting the fixed print reduction ratio from 70% to 100%. This
parameter functions only when the fixed print reduction is selected
---- ----
on Fax Parameter No. 24.
100 100%
(----) Setting a 4-digit password for secured polling. (See page 75)
*1 Invalid Selecting whether the machine retains the polled document(s) in
memory even after the document(s) is polled once.
2 Valid
1 Invalid Selecting whether the machine stamps the originals when storing
into memory.
*2 Valid
(depending on the Stamp setting on the Control Panel)
*1 Invalid Selecting whether the machine retains the document in memory if
it is not successfully transmitted.
2 Valid
1 Invalid Selecting whether the machine performs reduction when the
transmitting original is wider than the recording paper used at the
*2 Valid
receiving machine.
*1 Invalid All ring patterns.
2 Valid Select a ring pattern for automatic answering.
(Select Line-1 or Line-2 first, if you have the 2nd G3 Fax
Communication Port Kit installed)
1: A
2: B
3: C
4: D
Enter a 4-digit password for printing the received document(s) in
memory by using F8-5 (RCV TO MEMORY).
(----)
When F8-5 (RCV TO MEMORY) is set to ON, this parameter is not
selectable on the LCD display. (See page 97)
Enter a 4-digit Access Code to secure the machine from
(----)
unauthorized use. (See page 95)
PROGRAMMING YOUR MACHINE
Comments
Parameter No. 25.
received originals.
Standard ring pattern.
Double ring pattern.
Triple ring pattern (Short-Short-Long).
All other triple ring patterns, except the type C
described above.
31