Chapter 3. Quick Installation Guide; Tcp/Ip Configuration - TP-Link TL-WDR3600 User Manual

Chapter 3. Quick Installation Guide

This chapter will show you how to configure the basic functions of your N600 Wireless Dual
Band Gigabit Router using Quick Setup Wizard within minutes.
3.1

TCP/IP Configuration

The default IP address of the Router is 192.168.0.1 and the default Subnet Mask is 255.255.255.0.
These values can be changed as you desire. In this guide, we use all the default values for
description.
Connect the local PC to the Ethernet ports of the Router and then you can configure the IP
address for your PC by the following method: Set up the TCP/IP Protocol in "Obtain an IP
address automatically" mode on your PC. If you need instructions as to how to do this, please
refer to Appendix B: Configuring the
the PC.
Now, you can run the Ping command in the command prompt to verify the network connection
between your PC and the Router. The following example is in Windows 2000 OS.
Open a command prompt, and type ping 192.168.0.1, and then press Enter.
If the result displayed is similar to the Figure 3-1, it means the connection between your PC

and the Router has been established well.
If the result displayed is similar to Figure 3-2, it means the connection between your PC and

the Router failed.
TL-WDR3600
PC. Then the built-in DHCP server will assign IP address for
Figure 3-1 Success result of Ping command
- 9 -
N600 Wireless Dual Band Gigabit Router