Step 2: Press and hold the WPS button of the client device directly.
Step 3: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup
process.
Step 4: When the WPS LED is on, the client device has successfully connected to the Router.
Step 5: Refer back to your client device or its documentation for further instructions.
II. Enter the client device's PIN on the Router
Use this method if your client device does not have the WPS button, but has a Wi-Fi Protected
Setup PIN number.
Step 1: Keep the default WPS status as Enabled and click the Add device button in Figure
4-16, then Figure 4-19 will appear.
Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then
click Connect button.
Step 3: "Connect successfully" will appear on the screen of Figure 4-19, which means the
client device has successfully connected to the Router.
TL-WDR3600
N600 Wireless Dual Band Gigabit Router
Figure 4-17
Figure 4-18 Add A New Device
Figure 4-19 Add A New Device
- 37 -