TP-Link TL-WDR3600 User Manual page 26

11b only - Select if all of your wireless clients are 802.11b.

11g only - Select if all of your wireless clients are 802.11g.

11n only- Select only if all of your wireless clients are 802.11n.

11bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.

11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless

clients.
Channel Width - Select any channel width from the drop-down list. The default setting

is "Auto", which can adjust the channel width for your clients automatically.
Channel - This field determines which operating frequency will be used. It is not

necessary to change the wireless channel unless you notice interference problems with
another nearby access point. If you select "Auto", then the AP will select the best
channel automatically.
Wireless Security

Disable Security - The wireless security function can be enabled or disabled. If

disabled, the wireless stations will be able to connect the Router without
encryption.
Enable Security (WPA-PSK/WPA2-PSK) – It's selected by default, with the

default PSK password the same as the default PIN code.
No Change - If you chose this option, wireless security configuration will not

change!
These settings are only for basic wireless parameters. For advanced settings, please refer to
4.6 Wireless 2.4GHz.
7. Configure the basic parameters for 5GHz wireless network in the following screen as shown
in Figure 3-13, and then click Next.
TL-WDR3600 N600 Wireless Dual Band Gigabit Router
- 16 -