TP-Link TL-WDR3600 User Manual page 59

If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can establish a wireless
connection between wireless adapter and Router using either Push Button Configuration (PBC)
method or PIN method.

Note:
To build a successful connection by WPS, you should also do the corresponding configuration of
the new device for WPS function meanwhile.
I. Use the Wi-Fi Protected Setup Button
Use this method if your client device has a Wi-Fi Protected Setup button.
Step 1: Press the WPS/Reset button on the back panel of the Router, as shown in Figure 4-32.
You can also keep the default WPS status as Enabled and click the Add device button in
Figure 4-31. Then choose "Press the button of the new device in two minutes" and
click Connect, shown in Figure 4-33.
Step 2: Press and hold the WPS button of the client device directly.
Step 3: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup
process.
Step 4: When the WPS LED is on, the client device has successfully connected to the Router.
Step 5: Refer back to your client device or its documentation for further instructions.
II. Enter the client device's PIN on the Router
Use this method if your client device does not have the WPS button, but has a Wi-Fi Protected
Setup PIN number.
TL-WDR3600 N600 Wireless Dual Band Gigabit Router
Figure 4-32
Figure 4-33 Add A New Device
- 49 -