Utility Switch; Track Size Switches - DigiDesign D-Command Manual

Modes Switch (Page 4)
MmtTch (Latching Behavior for Switched Controls in Touch)
Toggles the preference that determines the behavior of
switched controls in Touch mode.
StdVCA (Standard VCA Logic for Group Attributes) Toggles the
preference that disables normal group linking behavior when
a VCA is assigned to a group
WrtWrn (Suppress Automation "Write To" Warnings Toggles
the preference that suppresses dialogs after invoking the Write
To Start/End/All commands
PanLnk (Use Absolute Pan Linking) Toggles the preference that
determines the behavior of pan controls in grouped tracks
SndTrm (Include Sends in Trim Mode) Toggles the preference
that determines whether Send Faders go into Trim mode
along with Main Volume
CtlUnd (Include Control Changes in Undo Queue) Toggles the
preference that determines whether mixer changes appear in
the Undo queue

Utility Switch

Utility switch
The Utility switch places the D-Command in Utility mode.
When D-Command is in Utility mode, this switch flashes.
Utility mode lets you view D-Command system information,
name D-Command units, run D-Command diagnostic tests,
and set certain D-Command hardware preferences. For com-
plete information on Utility mode, see Appendix A, "Utility
Mode"

Track Size Switches

Track Size Up
switch
Track Size Down
switch
Track Size controls
The Track Size Up and Down switches increase and decrease
the track height of all tracks where a selection or edit cursor is
present.
Chapter 9: Management Sections 83