Installation Instructions - Vinotemp WINE-MATE WM-1500HTD Installation, Use & Care Manual

NOTES:
• Mounting brackets, screws, gaskets and other seal materials are not included.
• Do not install any ducts onto the supply, return, intake and exhaust.
• Because of potential safety hazards under a certain condition, we strongly
recommend against the use of an extension cord. However, if you still elect to
use an extension cord, it is absolutely necessary that it will be a UL LISTED
3-wire grounding type appliance extension cord having a 3-blade grounding
plug and a 3-slot receptacle that will plug into the appliance. The marked
rating of the extension cord shall be 115 V, 15 A.
1. Cabinet Location
• Place the wine cabinet in a properly ventilated location. Otherwise, heat
exhausted by the cooling unit will build up and it will not operate properly.
• The exhaust area must not be closed space and must be ventilated. The
ambient temperatures shall not be higher than 78°F for a WM-1500HTD unit
and 95°F for a WM-2500HTD unit or lower than 50 °F.
1) Rear Exhaust Location
• Leave min 6 "clearance from the rear to the wall.
• Leave min 12" clearance from the top to the ceiling.
• Leave min 6" clearance from the left and right sides.
2) Front Exhaust Location
• Leave min 6" clearance from the front if left and right sides unobstructed.
• Or, leave min 36" clearance from the front if left and right sides obstructed
3) Top Exhaust Location
• Leave min 12" from the top to the ceiling.
• Leave min 2 "clearance from the rear to the wall.
• Leave min 2" clearance from the left and right sides.
4) Side Exhaust Location
• Leave min 6 "clearance from the left or right side to the wall.
• Leave min 12" clearance from the top to the ceiling.
2. Cooling Unit Installation
• The cooling unit produces cooling supplied into the cabinet, meanwhile it also
generates heat that must be exhausted outside the cabinet. So the cold-air
supply with return-air intake and hot-air exhaust with ambient-air side must be
separated and sealed. Foam tape gasket may be used to seal them. The
cooling unit must intake adequate fresh ambient-air to work properly. The

Installation Instructions

- 5 -