Vinotemp WINE-MATE WM-1500HTD Installation, Use & Care Manual page 19

high or not
b. Cabinet too large
cooling and
c. Ambient temperature too high
running
d. Exhaust restricted
continually
e. Malfunctioning fans
f.
g. Dirty Condenser
h. Iced evaporator
i.
j.
k. Undercharge or overcharge
l.
a. Improper cabinet insulation &
7. Unit running
too long
b. Exhaust restricted
c. Cabinet too large
d. Ambient temperature higher >
e. Dirty Condenser
f. Improper condenser air flow
a. Post-compressor
8. Fan motor
running but
b. Incorrect or loose wirings
compressor
c. Failed components
not running
d. Liquid
a. Fan blade stuck
9. Compressor
b. Incorrect or loose wirings
running but
c. Failed motors
fan not
running
a. Failed components
10.Temperature
high,
b. Improper condenser airflow
compressor
c. Dirty condenser
stopping
d. Overcharge of refrigerant
and starting
e. Discharge or suction pressure
but very
short
running time
a. Post-compressor
11.Fan running
too long
a. Low temperature setting
12.Temperature
b. Low ambient temperature
low
c. Air probe fault
seal
Evaporator or condenser airflow
Refrigeration system restriction
Refrigerant leak
Failed components
seal
°
90 F
fan
mode
refrigerant
compressor
too high
fan
mode for humidity modulation
- 18 -
opening
b. Check for excessive size
c. Check installation location
d. Leave minimum clearance for the
hot air exhaust and fresh air intake
sides
e. Check for both evaporator and
condenser fans
f. Check for air restrictions, air short-
circulation, grille directions
g. Clean condenser
h. Defrost and reset temperature
i. Call service
j. Call service
k. Call service
l. Check compressor windings, start
relay and overload protector
a. Check insulation, gasket and door
opening
b. Leave minimum clearance for the
hot air exhaust and fresh air intake
sides
c. Check for excessive size
d. Check for installation location
e. Clean condenser
f. Check for
circulation
running a. Check fan running time FON
b. Check all wirings and connections
c. Check start relay, start capacitor,
overload protector, compressor.
in the d. Call service.
a. Check for proper clearance
b. Check all wirings
c. Call service
a. Check compressor windings, start
relay and overload protector.
b. Check for condenser fan
c. Clean condenser
d. Call service for removing refrigerant
e. Call service for information
running a. Reset FON
a. Raise the setting
b. Move to another location
c. Change a new one
fan and air short