Table of Contents
Advertisement
CMOS Access
Access Denied
Access Allowed
(default)
6.
Replace the system unit cover (see "Replacing the
System Unit Cover" in Chapter 5).
7.
Connect system power cables and monitor.
8.
Power on the system. The system displays a system
configuration error message.
9.
Power off, unplug the system and monitor, and remove
the cover.
10.
Remove the jumper block from pins 26-28 and replace
it on pins 28-30.
11.
If you removed any expansion boards, replace them
(see "Replacing Expansion Boards" in Chapter 5).
12.
Replace the system unit cover. Reconnect the system
power cables and peripheral devices.
Power on the system.
13.
14.
Run Setup (see Chapter 4, NEC Drivers and Utilities).
6-10 Setting System Board Jumpers
Jumpers
21
22
25
26
26-28
29
30
21
22
28-30
25
26
29
30
Clear CMOS Jumper
Advertisement
Table of Contents
