Clear CMOS
Clear CMOS
Normal Operation
(Default)
Replace the system unit cover (see "Replacing the
6.
System Unit Cover in Chapter 5).
Connect system power cables and monitor.
7.
8.
Power on the system. The system displays a system
configuration error message.
9.
Power off, unplug the system and monitor, and remove
the cover.
10.
Remove the jumper block from pins 18-20 and replace
it on pins 20-22.
If you removed any expansion boards, replace them
11.
(see "Replacing Expansion Boards" in Chapter 5).
Replace the system unit cover. Reconnect the system
12.
power cables and peripheral devices.
Power on the system.
13.
14.
Run Setup (see Chapter 4, NEC Drivers and Utilities).
6-8 Setting System Board Jumpers
Jumpers
13
14
18-20
17
18
21
22
13
14
17
18
20-22
21
22
Clear CMOS Jumper