Barrel Sleeve Installation Instructions - Tippmann A-5TM E-GRIPTMKIT Owner's Manual

E
N
G
L
THIS IS NOT A TOY. MISUSE MAY CAUSE SERIOUS INJURY OR
I
DEATH. EYE, FACE, AND EAR PROTECTION DESIGNED FOR
S
PAINTBALL MUST BE WORN BY THE USER AND ANY PERSON
H
WITHIN RANGE. WE RECOMMEND YOU BE AT LEAST 18
YEARS OLD TO PURCHASE. PERSONS UNDER 18 MUST HAVE
ADULT SUPERVISION WHEN USING THIS PRODUCT. READ THE
OWNER'S MANUAL BEFORE USING THIS PRODUCT.
ALWAYS KEEP THE BARREL BLOCKING DEVICE INSTALLED
EXCEPT WHEN YOUR MARKER IS IN USE. ALWAYS MAKE
SURE THAT THE TRIGGER SAFETY IS IN THE SAFE MODE (SEE
INSTRUCTIONS ON PAGE 6) AND THE BARREL BLOCKING
DEVICE IS PROPERLY INSTALLED ON YOUR MARKER
ACCORDING TO THE INSTRUCTIONS TO PREVENT DAMAGE
TO PROPERTY, SERIOUS INJURY, OR DEATH.

Barrel Sleeve Installation Instructions

1. Insert the barrel sleeve onto the barrel and loop the cord over the top of the receiver
and position at the back of the grip as shown.
2. Adjust the cord length retainer up to the back of the grip by pulling the cord through it
until the retainer is snug against the back of the grip.
Keeping the cord as tight as possible, leave just enough
cord elasticity to pull the cord/retainer up over the top of
the marker to remove the barrel sleeve for firing.
3. After the cord length is properly adjusted, lock the cord length by
tying a knot in the cord against the back of the retainer as shown.
4. Before and after playing, inspect the barrel sleeve and replace if
the sleeve or cord is damaged, or there is a loss of cord elasticity.
5. Clean the barrel sleeve with plain, warm water and store out of sunlight in a dry area
when not in use.
WARNING
WARNING
Barrel Sleeve
4
Cord Length
Retainer