Tippmann A-5 RESPONSE Owner's Manual page 6

E-GRIP TM - Battery Installation or Replacement
STEP 1 - Getting Started: (9 volt battery not included)
E
1)Before installing air supply, install 9 volt battery as follows:
N
Battery Replacement: First follow unloading and air supply
G
removal instructions on page 16 and never disassemble a
marker that is under pressure.
L
2) Remove lower receiver as outlined in Receiver Disassembly
I
on page 17. It is not necessary to remove tank adapter to
S
replace battery.
H
3) Remove trigger assembly from lower receiver. To do so,
follow diagrams on next page as you push safety (A) out left
side of lower receiver and carefully lift trigger assembly out,
keeping it intact. It is not necessary to disassemble trigger
assembly to replace battery. It is not necessary to disassemble
lower receiver any further to replace battery.
4) Notice how battery wires from inside lower receiver are in
slot (B) beside top of armature pin (C) and the position of the
armature pin.
Now remove battery from inside lower receiver. Do not jerk it out
by the wires, carefully take it out. If you turn the receiver upside
down the armature pin may come out, this is ok, just be sure to
replace it.
Top View with Trigger
Assembly Removed
G D E
5) Carefully remove battery clip (E) from old
battery and place it on new battery (battery
terminals only fit one way in clip).
6) Make sure battery wires coming out of lower
receiver are in slot (B) beside armature pin (C).
7) Make sure armature pin is properly positioned
(C) in lower receiver and slides freely up and down.
TM
E-GRIP Battery Installation Instructions (continued on page 9)
Safety
H
A
B C
Trigger Switch
F
8
TM
E-GRIP Battery Installation Instructions (continued from page 8)
8) Insert attached battery into lower receiver bottom first (F)
with clip wires facing (E) back of receiver and to the right. Make
sure battery wires are not sitting on shelf (G) where trigger
assembly will rest.
9) Reinstall Trigger Assembly: Insert assembly and line up
safety holes - insert safety from left (H) to hold in place.
10) Visually inspect E-GRIP
trigger assembly is intact and the safety is in the "SAFE" red
not showing - to the right position.
left side
right side
The lower receiver is now ready for attachment to upper receiver.
11) Attach lower receiver to
upper receiver.
a) Align lower receiver front push
pin hole (#1) with upper receiver
hole (#1) then gently rock rear of
grip to align upper & lower push
left side
pin hole (#2).
b) With holes aligned, insert two
lower receiver push pins to attach.
Battery installation is complete.
right side
E
TM
lower receiver. Check that the
Top view of trigger assembly should look like this.
Make sure
there are no gaps
9
E
N
G
L
S
H
Safety "SAFE" position
(red not showing)
Upper Receiver
2
1
Lower
Receiver
I