Table Of Contents - Tippmann A-5 RESPONSE Owner's Manual

WARNING
E
THIS IS NOT A TOY. MISUSE MAY CAUSE SERIOUS INJURY OR
DEATH. EYE, FACE AND EAR PROTECTION DESIGNED FOR
N
PAINTBALL MUST BE WORN BY THE USER AND ANY PERSON
G
WITHIN RANGE. WE RECOMMEND AT LEAST 18 YEARS OLD
TO PURCHASE. PERSONS UNDER 18 MUST HAVE ADULT
L
SUPERVISION WHEN USING THIS PRODUCT. READ THE
I
OWNER'S MANUAL BEFORE USING THIS PRODUCT.
S
WARNING
H
BARREL SLEEVE INSTALLATION
• EXCEPT WHEN YOUR MARKER IS IN USE, ALWAYS MAKE
SURE THAT THE TRIGGER SAFETY IS IN SAFE MODE (SEE
INSTRUCTIONS ON PAGE 4), AND THE BARREL SLEEVE IS
PROPERLY INSTALLED ON YOUR MARKER AS FOLLOWS.
1) SLIDE BARREL INTO SLEEVE AND LOOP CORD OVER TOP
OF RECEIVER AND POSITION AT BACK OF GRIP AS SHOWN.
FOR FLATLINE
BARRELS SLIDE
FLATLINE INTO
SLEEVE AND
LOOP CORD ONTO
FRONT GRIP AND
POSITION AT BACK OF FRONT GRIP.
2) PINCH CORD LENGTH ADJUSTOR
BUTTON AND HOLD TO BACK OF GRIP AS YOU PULL CORD
THROUGH IT UNTIL ADJUSTOR IS SNUG AGAINST BACK OF
GRIP, THEN RELEASE BUTTON.
3) CHECK TO BE SURE THERE IS ENOUGH CORD ELASTICITY
TO PULL CORD/ADJUSTOR OFF OF GRIP TO REMOVE
BARREL SLEEVE FOR FIRING.
4) AFTER CORD LENGTH IS
ADJUSTED, LOCK CORD LENGTH
BY TYING A KNOT IN THE CORD
AGAINST THE BACK
OF THE ADJUSTOR AS SHOWN.
CORD
LENGTH ADJUSTOR
BUTTON
2
TIPPMANN
2955 Adams Center Road, Fort Wayne, IN 46803 USA
P) 260-749-6022 • F) 260-749-6619
www.tippmann.com
CONGRATULATIONS on your purchase of your Tippmann
paintball marker. We believe our A-5
the most accurate and durable paintball markers available ,
and proudly manufactured in the USA. All Tippmann
models will give many years of dependable service if cared for
properly.
Please take time to read this manual thoroughly and become
familiar with your Tippmann
and safety precautions before you attempt to load or fire
this marker. If you have a missing or broken part or need
assistance, please contact Tippmann
at 1-800-533-4831 for fast friendly service.

TABLE OF CONTENTS

Warning/Caution ................................................................. 2
Warning/Caution Barrel Sleeve Installation ......................... 2
Warning/Liability Statement ................................................ 4
Safety is your Responsibility ............................................... 4
Safe Mode = Turning The Safety On ................................... 4
Fire Mode = Turning The Safety Off .................................... 4
Getting Started .................................................................... 6
1. Prepare Marker for Air Supply Cylinder Installation ..... 6
2. Air Supply Cylinder Installation .................................... 6
3. Hopper and Cyclone TM
4. Rate of Fire Adjustments and Troubleshooting ............ 7
5. Velocity Adjustment ..................................................... 7
6. Rear Sight Adjustment ................................................. 7
Marker Model Specifications ............................................. 13
A-5 TM Schematic Standard Parts ................................... 14-15
Unloading Your Marker ..................................................... 16
Air Supply Cylinder Removal ............................................ 16
Cleaning & Maintenance ................................................... 16
Field Stripping / Receiver Disassembly ............................ 17
Repairing Air Supply Leaks ............................................... 22
Storage .............................................................................. 22
Warranty and Repair Policy .............................................. 23
Warranty or Repair Procedure .......................................... 23
TM
TM line of markers to be
TM A-5 TM markers' parts, operation,
Consumer Relations
TM
Feeder ..................................... 7
3
E
N
G
L
TM
I
S
TM A-5 TM
H