Console Redirection - Supero X7DAE User Manual

Chapter 4: BIOS
Event Log Capacity
This is a display to inform you of the event log capacity. It is not a setting.
View DMI Event Log
Highlight this item and press <Enter> to view the contents of the event log.
Event Logging
This setting allows you to Enable or Disable event logging.
ECC Event Logging
This setting allows you to Enable or Disable ECC event logging.
Mark DMI Events as Read
Highlight this item and press <Enter> to mark the DMI events as read.
Clear All DMI Event Logs
Select Yes and press <Enter> to clear all DMI event logs. The options are Yes
and No.
Console Redirection
Access the submenu to make changes to the following settings.
COM Port Address
This item allows you to specify which COM port to direct the remote console to:
Onboard COM A or Onboard COM B. This setting can also be Disabled.
BAUD Rate
This item allows you to set the BAUD rate for Console Redirection. The options
are 300, 1200, 2400, 9600, 19.2K, 38.4K, 57.6K, and 115.2K.
Console Type
This item allows you to choose the console redirection type. The options are VT100,
and VT-UTF8.
VT100,8bit, PC-ANSI, 7bit, PC ANSI, VT100+,
Flow Control
This item allows you to set the fl ow control for the console redirection. The options
are: None, XON/XOFF, and CTS/RTS.
Console Connection
This item allows you to decide how the console redirection is to be connected:
either Direct or Via Modem.
Continue CR after POST
This item allows you to decide whether you want to continue with console redirection
after POST routines. The options are On and Off.
4-17