X7DA8/X7DAE User's Manual
Compact Flash Master/Slave
Select
A Compact Flash Master/Slave Select
Jumper is located at JCF1. Close this
jumper to enable Compact Flash Card.
For the Compact Flash Card or the
Compact Flash Jumper (JCF1) to work
properly, you will need to connect the
Compact Flash Card power cable to
JWF1 first. Refer to the board layout
below for the location.
Alarm Reset
If three power supplies are installed
and Alarm Reset (JAR) is enabled, the
system will notify you when any of the
three power modules fails. Connect JAR
to a micro-switch to enable you to turn
off the alarm that is activated when a
power module fails. See the table on the
right for pin defi nitions.
LAN1/2
CD2 CD1
Line-In/
Line-
JPAC
Out
Mic
SIM LP IPMI
PCI-Exp x16
PCI-33MHz
CPU
PSF
J17
Fan 1
J3P
JAR
B
A
SCSI CTRL
320 SCSI Channel B
2-28
Compact Flash Card Master/
Slave Select
Jumper Defi nition
Open
Slave
Closed
Master
Alarm Reset
Pin Setting
Defi nition
Pin 1
Ground
Pin 2
+5V
8-pin PWR
A. Compact Flash Master/
Slave Select
B. Alarm Reset