Quick Reference - Supero X7DAE User Manual

Quick Reference (X7DA8/X7DAE)
Jumper Description
J3P 3rd PWR Failure Detect
JAR Alarm Reset
JBT1 CMOS Clear
JCF1 Compact Card Master/Slave Select
2 2
JI C1/JI C2 SMB to PCI-X Slots
2 2
JI C3/JI C4 SMB to PCI-E Slots
JPA1 (*X7DA8) SCSI Controller Enable
JPA2, JPA3 SCSI CHA(JPA2),CHB(JPA3)Term.En Off (Enabled) (*X7DA8)
JPAC Audio Enable
JPL1/ JPL2 GLAN1/GLAN2 Enable
JWD Watch Dog
Connector
ATX PWR (JPW1)
Aux. PWR/CPU PWR
Audio (JC1/JC2)
COM1/COM2
Compact PWR (JWF1)
DA1, DA2,
DIMM#1A-DIMM#4B
FAN 1-8
Floppy (J22)
FP Control (JF1)
GLAN 1/2 (JLAN1)
IDE1/IDE2(*Note)
JL1
LE1
OH LED (JOH1)
Parallel (J21)
PWR LED/SPKR (JD1)
PWR SMB (J17)
PSF (JP3)
SATA0-SATA5
SCSI (JA1/JA2)
SGPIO 1/2(J29,J30)
SMB (J18)
Slot 7
USB 0/1/2/3/4/5
WOL (JWOL)
WOR (JWOR)
Note: JIDE2 is for Compact Card Use only. Be sure to connect JWF1 to a power
supply to provide power to the compact fl ash card.
Description
Primary 24-Pin ATX PWR Connector
+12V 4-pin PWR (JWP2)/+12V 8-pin PWR(JPW3)
Audio Microphone (JC1), Line-In/Line-Out (JC2)
COM1/COM2 Serial Port Connectors
Compact Card PWR Connector
SCSI Activity LED Indicators
Memory DDRII Fully Buffered DIMM Slots
Fans 1-8 (Fan7: CPU Fan1, Fan8: CPU Fan2)
Floppy Disk Drive Connector
Front Control Panel Connector
G-bit Ethernet Ports
IDE1 Hard Drive (JIDE1)/Compact Flash Card (JIDE2)
Chassis Intrusion Header
5V Standby PWR LED Indicator (*Note6 on Pg.1-4)
Overheat LED
Parallel (Printer) Port
PWR LED(pins1-3)/Speaker Header (pins 4-7)
Power System Management (I
Power Supply Failure (See Chapter 2)
Intel SATA 0-5 Connectors
SCSI Channel A/Channel B Connectors (*X7DA8 only)
Serial General Purpose Input/Output Headers
System Management Bus Header
SIM Low Profi le IPMI Connector
Back Panel USB 0/1/2/3(JUSB1), FP USB4/5 (JUSB2)
Wake-on-LAN Header
Wake-on-Ring Header
1-5
Chapter 1: Introduction
Default Setting
Off (Disabled)
Off (Disabled)
See Chapter 2
On (Master)
Pins 2-3 (Disabled)
Pins 2-3 (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
2
C) Header