Installing Dimms - Supero X7DAE User Manual

X7DA8/X7DAE User's Manual
2-4

Installing DIMMs

Note: Check the Supermicro web site for recommended memory modules.
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Also note that the
memory is interleaved to improve performance (see step 1).
DIMM Installation (See Figure 2-1)
1. Insert the desired number of DIMMs into the memory slots, starting with Bank
1. (For optimal memory performance, please install four modules at a time.
Please refer to the table below.)
2. Insert each DIMM module vertically into its slot. Pay attention to the notch along
the bottom of the module to prevent inserting the DIMM module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules (see step 1 above).
Memory Support
The X7DA8/X7DAE supports up to 32 GB fully buffered (FBD) ECC DDR2 533/667
in 8 DIMMs. Populating DIMM modules with a pair (or pairs) of memory modules
that are of the same size and of the same type in Branch 1 and Branch 2 will result
in interleaved memory.
Note 1: Due to the OS limitations, some operating systems may not show more
than 4 GB of memory.
Optimized DIMM Population Configurations
Branch0
Number of Bank 1
DIMMs (Channel 0)
2 DIMMs 1A
4 DIMMs 1A
6 DIMMs 1A
8 DIMMs 1A
(*Notes: i. DIMM slot# specified: DIMM slot to be populated; "---": DIMM slot not to
be populated. ii. Both FBD 533 MHz and 667MHz DIMMs are supported; however,
you need to use the memory modules of the same speed and of the same type on a
motherboard. iii. Interleaved memory is supported when pairs of DIMM modules are
installed in both Branch 0 and Branch 1. iv. For memory to work properly, you need
to follow the restrictions listed above. )
Note 2: Due to memory allocation to system devices, memory remaining available
for operational use will be reduced when 4 GB of RAM is used. The reduction in
memory availability is disproportional. (Refer to the following Memory Availability
Table for details.)
CAUTION
Bank 2
(Channel 1)
------ 2A ------
------ 2A ------
1B 2A 2B
1B 2A 2B
2-6
Branch1
Bank 3 Bank 4
(Channel 2) (Channel 3)
------ ------ ------
3A ------ 4A
3A ------ 4A
3A 3B 4A
------
------
------
4B