Ide Connectors - Supero X7DAE User Manual

X7DA8/X7DAE User's Manual

IDE Connectors

There are two IDE Connectors (JIDE1:
Blue, JIDE2: White) on the mother-
board. The blue IDE connector (JIDE1)
is designated the Primary IDE Drive.
The white IDE connector (JIDE2) is
designated the Secondary IDE Drive,
reserved for Compact Flash Card use
only. (See the note below.) See the
table on the right for pin defi nitions.
Note: JIDE2 (the white slot) is reserved
for Compact Flash Card only. Do not
use it for other devices. If JIDE2 is
populated with a Compact Flash Card,
JIDE1 (the blue slot) will be available for
one device only. For the Compact Flash
Card to work properly, you will need to
connect a power cable to JWF1 fi rst.
LAN1/2
CD2 CD1
Line-In/
Line-
JPAC
Out
Mic
SIM LP IPMI
PCI-Exp x16
PCI-33MHz
Pin#
1
3
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
37
39
CPU
PSF
J17
Fan 1
J3P
JAR
SCSI CTRL
C
320 SCSI Channel B
2-34
IDE Drive Connectors
Pin Defi nitions
Defi nition Pin # Defi nition
Reset IDE 2 Ground
Host Data 7 4 Host Data 8
Host Data 6 6 Host Data 9
Host Data 5 8 Host Data 10
Host Data 4 10 Host Data 11
Host Data 3 12 Host Data 12
Host Data 2 14 Host Data 13
Host Data 1 16 Host Data 14
Host Data 0 18 Host Data 15
Ground 20 Key
DRQ3 22 Ground
I/O Write 24 Ground
I/O Read 26 Ground
IOCHRDY 28 BALE
DACK3 30 Ground
IRQ14 32 IOCS16
Addr1 34 Ground
Addr0 36 Addr2
Chip Select 0 38 Chip Select 1
Activity 40 Ground
8-pin PWR
A. IDE#1
B. IDE#2 (Compact Flash)
B A