Fortinet 548B Administration Manual page 141

7.2.16.5 show fip-snooping vlan
This command displays FIP snooping whether enable or disable on specific VLAN.
Syntax
show fip-snooping vlan {< 1-3965> | all}
<1 - 3965> - VLAN ID.
all - This command represents all interfaces.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Vlan ID: fip-snooping function status on the specific VLAN.
7.2.16.6 fip-snooping
The FIP snooping function is disabled by default. Only after enabling it, are the FIP related CLIs under
VLAN and interface mode visible. The FIP-snoop process also starts after the "fip-snooping" command
is enabled. Once the feature is enabled, the FIP-snoop packets and FCoE packets are dropped, unless
explicitly enabled on a per-VLAN basis. If FIP snooping is enabled, all the FIP frames are snooped and
security ACLs are added. FCoE traffic is blocked on all ports until the device re-initializes with FIP. If the
feature is disabled, snooping is removed and all programmed ACLs and internal data are cleaned up.
Syntax
fip-snooping
no fip-snooping
no - This command disables fip snooping function.
Default Setting
Disabled
Command Mode
Global Config
- 141 -