Voice Vlan Data Priority - Fortinet 548B Administration Manual

7.11.2.4 voice vlan
This command is used to enable/disable Voice VLAN Admin Mode.
Syntax
voice vlan
no voice vlan
no - This command disables the Voice VLAN capability on this switch.
Default Setting
Disabled
Command Mode
Global Config
This command configures the Voice VLAN capability on the interface.
Syntax
voice vlan { <vlanid-id> | dot1p <priority> | none | untagged }
no voice vlan
<vlan-id> - Configure the IP phone to forward all voice traffic through the specified VLAN.
<dot1p> - Configure th IP phone to use 802.1p priority tagging for voice traffic and to use the default
native VLAN (0) to carry all traffic. The valid <priority> range is 0 to 7.
<none> - Allow the IP phone to use its own configuration to send untagged voice traffic.
<untagged> - Configure the phone to send untagged voice traffic.
no - This command disables the Voice VLAN capability on this switch.
Default Setting
Disabled
Command Mode
Interface Config

7.11.2.5 voice vlan data priority

Use this command to either trust or entrust the data traffic arriving one the Voice VLAN port.
- 282 -