Spanning Tree Commands - Fortinet 548B Administration Manual

Syntax
serviceport ipv6 gateway <gateway-address>
no serviceport ipv6 gateway
<gateway-address>: Gateway address in IPv6 global or link-local address format.
no - This command remove IPv6 gateways on the service port interface.
Only a single IPv6 gateway address can be configured for the service port. There may be a
i
combination of IPv6 prefixes and gateways that are explicitly configured and those that are
set through auto-address configuration with a connected IPv6 router on their service port
interface.
Default Setting
None
Command Mode
Global Config
7.4

Spanning Tree Commands

This section provides detailed explanation of the spanning tree commands. The commands are divided
into two functional groups:
−
Show commands display spanning tree settings, statistics, and other information.
−
Configuration Commands configure features and options of the switch. For every configuration
command there is a show command that displays the configuration setting.
7.4.1 Show Commands
7.4.1.1 show spanning-tree
This command displays spanning tree settings for the common and internal spanning tree. The following
details are displayed.
Syntax
show spanning-tree
Default Setting
None
Command Mode
- 201 -