Advanced Nat/Route Mode Settings - Fortinet FortiGate FortiGate-800 Installation And Configuration Manual

Preparing to configure NAT/Route mode

Advanced NAT/Route mode settings

42
Table 10: NAT/Route mode settings
Administrator Password:
Internal interface
External interface
Internal servers
If you provide access from the Internet to a web server, mail server,
IMAP server, or FTP server installed on an internal network, add the IP
addresses of the servers here.
Use Table 11 to gather the information that you need to customize advanced
FortiGate NAT/Route mode settings.
Table 11: Advanced FortiGate NAT/Route mode settings
DHCP:
External
PPPoE:
interface
If your ISP supplies you with an IP address using PPPoE, record your
PPPoE user name and password.
DHCP server
The FortiGate unit includes a DHCP server that you can configure to
automatically set the addresses of the computers on your internal network.
IP:
Netmask:
IP:
Netmask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
Web Server:
SMTP Server:
POP3 Server:
IMAP Server:
FTP Server:
If your Internet Service Provider (ISP) supplies you with
an IP address using DHCP, no further information is
required.
User name:
Password:
Starting IP:
Ending IP:
Netmask:
Default Route:
DNS IP:
NAT/Route mode installation
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
Fortinet Inc.