Configuring The Fortigate Unit As A Pptp Gateway - Fortinet FortiGate FortiGate-800 Installation And Configuration Manual

Configuring PPTP

Configuring the FortiGate unit as a PPTP gateway

258
Use the following procedures to configure the FortiGate unit as a PPTP gateway:
To add users and user groups
Add a user for each PPTP client.
1 Go to User > Local.
2 Add and configure PPTP users.
For information about adding and configuring users, see
configuring authentication" on page
3 Go to User > User Group.
4 Add and configure PPTP user groups.
For information about adding and configuring user groups, see
groups" on page
To enable PPTP and specify an address range
1 Go to VPN > PPTP > PPTP Range.
2 Select Enable PPTP.
3 Enter the Starting IP and the Ending IP for the PPTP address range.
4 Select the User Group that you added in
5 Select Apply to enable PPTP through the FortiGate unit.
Figure 64: Example PPTP Range configuration
To add a source address
Add a source address for every address in the PPTP address range.
1 Go to Firewall > Address.
2 Select the interface to which PPTP clients connect.
This can be an interface, VLAN subinterface, or zone.
224.
229.
"Adding user names and
"To add users and user groups" on page
PPTP and L2TP VPN
"Configuring user
258.
Fortinet Inc.