Dmz And User-Defined Interfaces; Using The Setup Wizard; Starting The Setup Wizard; Reconnecting To The Web-Based Manager - Fortinet FortiGate FortiGate-800 Installation And Configuration Manual

NAT/Route mode installation

DMZ and user-defined interfaces

Using the setup wizard

Starting the setup wizard

Reconnecting to the web-based manager

FortiGate-800 Installation and Configuration Guide
Use Table 12 to record the IP addresses and netmasks of the FortiGate DMZ and
user-defined interfaces if you are configuring them during installation. The HA
interface is configured during HA installation.
.
Table 12: DMZ and user-defined interfaces (Optional)
DMZ IP:
_____._____._____._____
1 IP:
_____._____._____._____
2 IP:
_____._____._____._____
3 IP:
_____._____._____._____
4 IP:
_____._____._____._____
From the web-based manager, you can use the setup wizard to do the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see "Connecting to the web-based manager" on page
1 In the web-based manager, select Easy Setup Wizard (the middle button in the upper-
right corner of the web-based manager).
2 Select the Next button to step through the wizard pages.
3 Use the information that you gathered in
You can also use the information in
4 Confirm the configuration settings, and then select Finish and Close.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For example, for each server
located on the Internal network the FortiGate unit adds an External->Internal firewall policy.
If you changed the IP address of the internal interface while you were using the setup
wizard, you must reconnect to the web-based manager using a new IP address.
Browse to https:// followed by the new IP address of the internal interface. Otherwise,
you can reconnect to the web-based manager by browsing to https://192.168.1.99.
You are now finished the initial configuration of your FortiGate unit, and can proceed
to "Completing the configuration" on page
Netmask:
_____._____._____._____
Netmask:
_____._____._____._____
Netmask:
_____._____._____._____
Netmask:
_____._____._____._____
Netmask:
_____._____._____._____
Table 10 on page 42
Table 11 on page 42.
49.
Using the setup wizard
28.
to fill in the wizard fields.
43