Fortinet FortiGate FortiGate-800 Installation And Configuration Manual page 105

System status
FortiGate-800 Installation and Configuration Guide
Switching to the backup firmware image
Use this procedure to switch the FortiGate unit to operating with a backup firmware
image that you previously installed. When you switch the FortiGate unit to the backup
firmware image, the FortiGate unit operates using the configuration that was saved
with that firmware image.
If you install a new backup image from a reboot, the configuration saved with this
firmware image is the factory default configuration. If you use the procedure
"Switching back to the default firmware image" on page 106
firmware image that was previously running as the default firmware image, the
configuration saved with this firmware image is restored.
To switch to the backup firmware image
1 Connect to the CLI using the null-modem cable and FortiGate console port.
2 Enter the following command to restart the FortiGate unit:
execute reboot
As the FortiGate units starts, a series of system startup messages are displayed.
When the following message appears:
Press any key to enter configuration menu.....
......
3 Immediately press any key to interrupt the system startup.
Note: You have only 3 seconds to press any key. If you do not press a key soon enough, the
FortiGate unit reboots and you must log in and repeat the
If you successfully interrupt the startup process, the following message appears:
[G]: Get firmware image from TFTP server.
[F]: Format boot device.
[B]: Boot with backup firmware and set as default.
[Q]: Quit menu and continue to boot with default firmware.
[H]: Display this list of options.
Enter G,F,B,Q,or H:
4 Type B to load the backup firmware image.
The FortiGate unit loads the backup firmware image and restarts. When the FortiGate
unit restarts, it is running the backup firmware version and the configuration is set to
factory default.
Changing the FortiGate firmware
to switch to a backup
execute reboot command.
105