Configuring The Transparent Mode Management Ip Address; Configure The Transparent Mode Default Gateway; Completing The Configuration; Setting The Date And Time - Fortinet FortiGate FortiGate-800 Installation And Configuration Manual

Completing the configuration

Configuring the Transparent mode management IP address

Configure the Transparent mode default gateway

Completing the configuration

Setting the date and time

Enabling antivirus protection

62
1 Make sure that you are logged into the CLI.
2 Set the management IP address and netmask to the IP address and netmask that you
recorded in Table 16 on page
set system management ip <IP address> <netmask>
Example
set system management ip 10.10.10.2 255.255.255.0
3 Confirm that the address is correct. Enter:
get system management
The CLI lists the management IP address and netmask.
1 Make sure that you are logged into the CLI.
2 Set the default route to the default gateway that you recorded in
Enter:
set system route number <number> gw1 <IP address>
Example
set system route number 0 gw1 204.23.1.2
Use the information in this section to complete the initial configuration of the FortiGate
unit.
For effective scheduling and logging, the FortiGate system date and time must be
accurate. You can either manually set the system date and time or configure the
FortiGate unit to automatically keep its time correct by synchronizing with a Network
Time Protocol (NTP) server.
For information about setting the FortiGate system date and time, see
date and time" on page
You can protect users on your internal network from downloading a virus from the
Internet.
1 Go to Firewall > Policy > Internal->External.
2 Select Edit to edit this policy.
3 Select Anti-Virus & Web filter to enable antivirus protection for this policy.
4 Select the Scan Content Profile.
5 Select OK to save the changes.
59. Enter:
169.
Transparent mode installation
Table 16 on page
"Setting system
Fortinet Inc.
59.