Fortinet FortiGate FortiGate-800 Installation And Configuration Manual page 68

Transparent mode configuration examples
68
Note: This is an example configuration only. To configure a static route, you require a
destination IP address.
Figure 12: Static route to an external destination
Gateway IP 192.168.1.2
Management IP 192.168.1.1
FortiGate-800
General configuration steps
1 Set the FortiGate unit to operate in Transparent mode.
2 Configure the Management IP address and Netmask of the FortiGate unit.
3 Configure the static route to the FortiResponse server.
4 Configure the default route to the external network.
Web-based manager example configuration steps
To configure the basic FortiGate settings and a static route using the web-based
manager:
1 Go to System > Status.
• Select Change to Transparent Mode.
• Select Transparent in the Operation Mode list.
• Select OK.
The FortiGate unit changes to Transparent mode.
Internet
Upstream
Router
I N T E R N A L E X T E R N A L D M Z HA 1 2 3 4 CONSOLE USB
Esc Enter
P W R
8
Internal Network
Management
Computer
Transparent mode installation
24.102.233.5
FortiResponse
Distribution
Network (FDN)
DNS
DMZ
Fortinet Inc.