Using the setup wizard
Using the setup wizard
Changing to Transparent mode using the web-based manager
Starting the setup wizard
Reconnecting to the web-based manager
60
From the web-based manager, you can use the setup wizard to begin the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see
"Connecting to the web-based manager" on page
The first time that you connect to the FortiGate unit, it is configured to run in
NAT/Route mode.
To switch to Transparent mode using the web-based manager
1
Go to System > Status.
2
Select Change to Transparent Mode.
3
Select Transparent in the Operation Mode list.
4
Select OK.
To reconnect to the web-based manager, change the IP address of the management
computer to 10.10.10.2. Connect to the internal or DMZ interface and browse to
https:// followed by the Transparent mode management IP address. The default
FortiGate Transparent mode management IP address is 10.10.10.1.
1
Select Easy Setup Wizard (the middle button in the upper-right corner of the
web-based manager).
2
Use the information that you gathered in
Select the Next button to step through the wizard pages.
3
Confirm your configuration settings, and then select Finish and Close.
If you changed the IP address of the management interface while you were using the
setup wizard, you must reconnect to the web-based manager using the new IP
address. Browse to https:// followed by the new IP address of the management
interface. Otherwise, you can reconnect to the web-based manager by browsing to
https://10.10.10.1. If you connect to the management interface through a router, make
sure that you have added a default gateway for that router to the management IP
default gateway field.
Transparent mode installation
Table 16 on page 59
to fill in the wizard fields.
28.
Fortinet Inc.
Need help?
Do you have a question about the FortiGate FortiGate-800 and is the answer not in the manual?