Completing The Configuration; Configuring The Dmz Interface; Configuring Interfaces 1 To 4; Setting The Date And Time - Fortinet FortiGate FortiGate-800 Installation And Configuration Manual

NAT/Route mode installation

Completing the configuration

Configuring the DMZ interface

Configuring interfaces 1 to 4

Setting the date and time

Changing antivirus protection

FortiGate-800 Installation and Configuration Guide
Use the information in this section to complete the configuration of the FortiGate unit.
Use the following procedure to configure the DMZ interface:
1 Log into the web-based manager.
2 Go to System > Network > Interface.
3 Choose the dmz interface and select Modify
4 Change the IP address and Netmask as required.
5 Select Apply.
Use the following procedure to configure the eight user-defined interfaces:
1 Log into the web-based manager.
2 Go to System > Network > Interface.
3 Choose a user-defined interface and select Modify
Select from port1 to port4.
4 Change the IP address and Netmask as required.
5 Select Apply.
For effective scheduling and logging, the FortiGate system date and time must be
accurate. You can either manually set the system date and time or configure the
FortiGate unit to automatically keep its time correct by synchronizing with a Network
Time Protocol (NTP) server.
For information about setting the FortiGate system date and time, see
date and time" on page
To change how antivirus protection to protects users on your internal network from
downloading a virus from the Internet:
1 Go to Firewall > Policy > Internal->External.
2 Select Edit to edit this policy.
3 Select Anti-Virus & Web filter to enable antivirus protection for this policy.
4 Select a different Content Profile to change how antivirus protection is applied for this
policy.
For a description of each of the content profiles, see
5 Select OK to save the changes.
169.
Completing the configuration
.
.
"Setting system
"Content profiles" on page 218.
49