Fortinet FortiGate FortiGate-800 Installation And Configuration Manual page 193

Firewall configuration
FortiGate-800 Installation and Configuration Guide
Maximum You can also use traffic shaping to limit the amount of bandwidth available
through the firewall for a policy. Limit bandwidth to keep less important
Bandwidth
services from using bandwidth needed for more important services.
Traffic Priority Select High, Medium, or Low. Select Traffic Priority so that the FortiGate unit
manages the relative priorities of different types of traffic. For example, a
policy for connecting to a secure web server needed to support e-commerce
traffic should be assigned a high traffic priority. Less important services
should be assigned a low priority. The firewall provides bandwidth to low-
priority connections only when bandwidth is not needed for high-priority
connections.
Authentication
Select Authentication and select a user group to require users to enter a user name
and password before the firewall accepts the connection. Select the user group to
control the users that can authenticate with this policy. For information about adding
and configuring user groups, see
add user groups before you can select Authentication.
You can select Authentication for any service. Users can authenticate with the firewall
using HTTP, Telnet, or FTP. For users to be able to authenticate you must add an
HTTP, Telnet, or FTP policy that is configured for authentication. When users attempt
to connect through the firewall using this policy they are prompted to enter a firewall
username and password.
If you want users to authenticate to use other services (for example POP3 or IMAP)
you can create a service group that includes the services for which you want to
require authentication, as well as HTTP, Telnet, and FTP. Then users could
authenticate with the policy using HTTP, Telnet, or FTP before using the other service.
In most cases you should make sure that users can use DNS through the firewall
without authentication. If DNS is not available users cannot connect to a web, FTP, or
Telnet server using a domain name.
Anti-Virus & Web filter
Enable antivirus protection and web filter content filtering for traffic controlled by this
policy. You can select Anti-Virus & Web filter if Service is set to ANY, HTTP, SMTP,
POP3, IMAP, or FTP or to a service group that includes the HTTP, SMTP, POP3,
IMAP, or FTP services.
Select a content profile to configure how antivirus protection and content filtering is
applied to the policy. For information about selecting a content profile, see
profiles" on page 218.
"Configuring user groups" on page
Adding firewall policies
229. You must
"Content
193