About The Programmable Features - Excalibur RS-11 Operating & Installation Instructions Manual

10
Exiting Programming Mode:
Simply allow the unit to time out of Features Programming Mode by not perform-
ing any programming actions for 15 seconds; or, turn the ignition "On" to immediately
exit the programming mode.
The unit indicates its exit from Features Programming Mode with 2 short and 1
long Status Lights flashes and the parking lights turning off.

About the Programmable Features

Of the five Programmable Features, four are strictly "installation"-related, and one is "op-
erational" in nature. Installation-related features adapt the unit to certain vehicle situa-
tions; these are to be utilized at the time of the installation only.
Only Features # 1 has a "daily use" benefit to the vehicle operator:
#
• Feature 1 is "Engine Running Time"
run time before automatic shut-off is adjustable. A 10 minute run time is the factory
setting, with options of 20, 30 or 40 minutes. When programming press the brake pedal
1 time for the default-set 10 minute run time; or press the brake 2 times for 20 minutes;
3 times for 30 minutes; or 4 times for 40 minutes.
• Feature # 2 is "Starter Cranking Time",
for the Smart Start voltage sensing engine detection method (page 34). When using
Smart Start, a longer starter cranking time may be used for engines which do not start on
the first remote start attempt. Programming choices are: .5 second (1 brake press, the
default setting); .75 second (2 brake presses); 1.25 second (3 brake presses); and 1.5
. When it remotely starts the engine, the
which sets the base starter cranking time
22 Gauge Blue Wire:
500mA ( - ) Ignition Output
Connection If Needed.
This 22 gauge Blue wire is a
500mA Negative output,
which has the same
operation as the
12 gauge Blue
Red Wire
Ignition output.
NOTE: If an
additional Acc-
Red
essory output is
3-pin
needed, use the
Harness
programmable
built-in relay (Yellow/Green wire).
Wiring Connections - 12 Wire Harness
NOTE: On the 12
Wire Harness, the
To Additional
Optional
Starter Circuit
Relay
30
86
85
87a
87
To Additional
Ignition Circuit
30
86
85
87a
Optional
87
Relay
20-Gauge Gray Wire: is NOT Used .
20-Gauge Brown Wire: is NOT Used .
19
Fused
constant
12 Volts
Fused
constant
12 Volts