Table of Contents
Advertisement
12
Installation Instructions
After reading this manual, start the installation by affixing the WARN-
ING DECAL to a visible area in the engine compartment!
Do not attempt to install this Remote Car Starter into a manual transmission
vehicle! Doing so could cause serious property damage, personal injury,
and will void all warranties!
Be aware of, and avoid, any airbag circuitry! Due to the fact that an installer
may not be in a normal, upright seated position, severe injury may occur in
an accidental airbag deployment!
The use of a Digital Multimeter (DMM) or Volt-Ohm Meter (VOM) instead of a
standard testlight is required. This can greatly reduce the risk of an acciden-
tal airbag deployment or on-board computer damage.
Battery gases are explosive! Avoid sparks and do not smoke while working
near the vehicle's battery!
Always protect wires routed through the firewall from sharp metal edges and
hot parts of the engine! Always fuse positive wires at their source!
Installation Considerations: This entire booklet should be read before starting the
installation. An understanding of which control module wires are to be used and their
functions is essential. Installations will vary from car to car, as some control module wires
are required, while others are optional. Before starting the installation, it should be deter-
the 3-pin Red port to energize the second Starter wire.
Note: If a security system is present which utilizes a starter interrupt circuit,
the Green wire must be connected to the Starter Motor side of the interrupt.
12-Gauge Yellow Wire:
Connection Required .
Connect the Yellow wire to the vehicle's Ignition wire (also known
as "Primary Ignition"). This wire will show +12 Volts when the ignition key is in the "Run"
and "Start" positions and no voltage in the "Off" and "Accessory" positions. This wire is
found in the ignition switch wiring harness.
Note: If two Primary Ignition wires are present, use the Yellow/Green wire for the second,
or configure an optional relay to the 3-pin Red port.
12-Gauge White Wire:
Connection Required .
Connect the White wire to the vehicle's Accessory wire. This
circuit supplies power to the Heat, Ventilation and Air Conditioning (HVAC) system. This
wire will show 12 Volts when the ignition key is in the "Run" and "Accessory" positions and
No voltage in the "Start" and "Off" positions. The connection point for this wire is also found
in the ignition switch wiring harness.
12-Gauge Yellow/Green Wire:
Connection If Needed .
The Yellow/Green wire is an additional output which can be
programmed to operate as an Ignition output, Accessory output or Starter output. As re-
ceived, it is programmed as an Ignition #2 output. This wire may be used in cases where
the vehicle has more than one of any of these three circuits.
17
Ignition Output
Accessory Output
Programmable Output
Hide quick links:
Advertisement
Table of Contents
