Connecting The Printer Using The Parallel Cable16 - NEC SuperScript 1400 User Manual

C
ONNECTING THE
P C
THE ARALLEL
To connect the SuperScript 1400 printer we recommend using
an IEEE 1284-compliant bidirectional parallel cable that is no
more than 6 feet in length.
1. Make sure the printer and the computer are turned OFF.
2. Plug the appropriate end of the parallel cable into the
connector on the back of the printer. Fasten the clips at
the end of the connector into the notches on the plug (A).
A
16 Chapter 2, Getting Started
P U
RINTER SING
ABLE
3. Plug the other end of the cable into the appropriate
parallel connector on your computer (B).
4. Connect the Power Cord to the back of the printer. Plug
the other end of the Power Cord into a properly
grounded outlet (C).
note:
Do not turn on your computer until you have
successfully printed out a Configuration Sheet. Follow the
directions on page 18.
B
C