Microcom 326M User Manual page 29

Chapter 4
Byte Mode
Responses Text and Verbose Mode Responses
(ASCII Hex)
0x87
0x8A
0x8F
0x90
0x91
0xB0
0xC0
0xC1
0xD0 >TEMPERATURE OUT OF RANGE<
0xD1
0xD2
0xD3
0xD4
0xD5
0xD6
0xD7
0xD9
0xDA
0xDB
0xDC
0xE1
326M User's Guide
>STOCK ADVANCED<
>FLASH DEFRAGMENTING<
>STOCK NOT LOADED<
>RETRACTION DELAY<
>PRINT DELAY<
>FLASH MEMORY LOW<
>BUTTON 1 TAPPED<
>BUTTON 1 HELD<
>NONEXISTENT COMMAND<
>INCOMPLETE COMMAND<
>ZIP FILE ERROR<
>FILE CONVERSION ERROR<
>UNSUPPORTED FILE TYPE<
>FILE NOT FOUND<
>INADEQUATE ACCESS MODE<
>FILE IS READ ONLY<
>INADEQUATE FLASH SPACE<
>I/O FAILURE<
>FONT/GRAPHIC NOT FOUND<
>SWITCH 0 ACTUATED<
Printer Modes
Definition
The media has been advanced.
Flash file system is optimizing
memory.
The printer was powered up with
out media installed.
The retraction has been
delayed.
The printing has been delayed.
The Flash memory file space is
95% full.
The print button has been
pressed.
The print button has been held.
The print head temperature is
out of operating range.
The received command does not
exist.
The received command is not
complete.
The received Zipped file has an
error.
The file was not converted
properly.
The received file is not
recognized.
The requested file does not exist
or cannot be found.
Incorrect password to a higher
access level.
File is read only and cannot be
deleted.
Cannot save an item to the flash
memory due to lack of space.
The Input/Output circuitry has
failed.
The requested file does not exist
or cannot be found.
Switch 0 has been actuated.
17