Wan Setup; Figure 2-11 Menu 2 - Wan Setup - ZyXEL Communications Prestige 310 User Manual

Prestige 310 Broadband Sharing Gateway
FIELD
DDNS Type field. Press [SPACE BAR] and then [ENTER] to
select Yes. When Yes is selected, traffic is redirected to a URL
that you have previously specified (see
details).
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
If you have a private WAN IP address, then you can not use Dynamic DNS.
2.8

WAN Setup

This section describes how to configure the WAN using Menu 2 - WAN Setup. From the main menu, enter 2
to display menu 2.
ZyXEL recommends you configure this menu even if your ISP does not require
Press Space Bar to Toggle
This screen allows you to configure the WAN port's MAC Address by either using the factory default or
cloning the MAC address from a workstation on your LAN. Once it is successfully configured, the address
will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the setting in
menu 2 or upload a different rom file.
The following table contains instructions on how to configure your WAN setup.
2-14
DESCRIPTION
MAC address athentication.
Menu 2 - WAN Setup
MAC Address:
Assigned By=IP address attached on LAN
IP Address= 192.168.1.33
Press ENTER to Confirm or ESC to Cancel:
Figure 2-11 Menu 2 — WAN Setup
www.dyndns.org for
Hardware Installation and Initial Setup
EXAMPLE