Figure 10-2 Ftp Session Example; Table 10-2 General Commands For Third Party Ftp Clients - ZyXEL Communications Prestige 310 User Manual

Prestige 310 Broadband Sharing Gateway
Example of FTP Commands from the DOS Prompt
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Third Party FTP Clients
The following table describes some of the commands that you may see in third party FTP clients.

Table 10-2 General Commands for Third Party FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory
TFTP and FTP over WAN
TFTP, FTP and Telnet over the WAN will not work when:
1. You have disabled Telnet service in menu 24.11.
2. You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet service.
3. The IP you entered in the Secured Client IP field in menu 24.11 does not match the client IP. If it does
not match, the Prestige will disconnect the Telnet session immediately.
4. You have an SMT console session running.
10-4

Figure 10-2 FTP Session Example

Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your
ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
DESCRIPTION
Firmware and Configuration Maintenance