Boot Commands - ZyXEL Communications Prestige 310 User Manual

Prestige 310 Broadband Sharing Gateway
The BootModule AT commands execute from within the router's bootup software, when debug mode is
selected before the main router firmware (ZyNOS) is started. When you start up your Prestige, you are given
a choice to go into debug mode by pressing a key at the prompt shown in the following screen. In debug
mode you have access to a series of boot module commands, for example ATUR (for uploading firmware)
and (for uploading the configuration file). These are discussed in the Firmware and Configuration
ATLC
Maintenance chapter of this User's Guide.
Bootbase Version: V2.02 | 10/11/2002 13:58:03
RAM: Size = 8192 Kbytes
DRAM Post: Testing:
FLASH: Intel 16M
ZyNOS Version: V324\wa0b05 | 3/5/2001 18:00:34
Press any key to enter debug mode within 3 seconds.
Enter ATHE to view all available Prestige boot module commands as shown in the next screen. ATBAx
allows you to change the console port speed. The x denotes the number preceding the colon to give the
console port speed following the colon in the list of numbers that follows; for example, ATBA3 will give a
console port speed of 9600 Kbps. ATSE displays the seed that is used to generate a password to turn on the
debug flag in the firmware. The ATSH command shows product related information such as boot module
version, vendor name, product model, RAS code revision, etc. ATGO allows you to continue booting the
system. Most other commands aid in advanced troubleshooting and should only be used by qualified
engineers.
N
8192K OK
Diagram 6 Option to Enter Debug Mode
Appendix E

Boot Commands

Appendix E