Restore Using Ftp Or Tftp; Figure 10-7 Telnet Into Menu - ZyXEL Communications Prestige 310 User Manual

Prestige 310 Broadband Sharing Gateway

10.3.1 Restore Using FTP or TFTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file upload in this
chapter.
To transfer the firmware and configuration file to your workstation, follow the
procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-spt is the
remote file name on the router. This restores the configuration to
your router.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your router manual.
Step 1.
Launch the FTP client on your computer.
Step 2. Enter "open", followed by a space and the IP address of your Prestige.
Step 3. Press [ENTER] when prompted for a username.
Step 4.
Enter your password as requested (the default is "1234").
Step 5. Enter "bin" to set transfer mode to binary.
Step 6. Find the "rom" file (on your computer) that you want to restore to your Prestige.
Step 7. Use "put" to transfer files from the Prestige to the computer, for example, "put config.rom rom-0"
transfers the configuration file on the Prestige to your computer and renames it "config.rom". See
earlier in this chapter for more information on filename conventions.
Step 8. Enter "quit" to exit the ftp prompt. The Prestige will automatically restart after a successful
restore process.
10-8
Menu 24.6 -- System Maintenance - Restore Configuration
Press ENTER to Exit:

Figure 10-7 Telnet into Menu 24.6

Firmware and Configuration Maintenance