Restore Via Console Port; Figure 10-8 Restore Using Ftp Or Tftp Session Example; Figure 10-9 System Maintenance - Restore Configuration; Figure 10-10 System Maintenance - Starting Xmodem Download Screen - ZyXEL Communications Prestige 310 User Manual

Restore Using FTP or TFTP Session Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit

Figure 10-8 Restore Using FTP or TFTP Session Example

Refer to the TFTP and FTP over WAN section to read about configurations that disallow TFTP and FTP to
work over WAN.

10.3.2 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter "y" at the following screen.
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Figure 10-9 System Maintenance — Restore Configuration
Step 2.
The following screen indicates that the Xmodem download has started.
Starting XMODEM download (CRC mode) ...
CCCCCCCCC
Figure 10-10 System Maintenance — Starting Xmodem Download Screen
Step 3.
Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the
following screen.
Firmware and Configuration Maintenance
Prestige 310 Broadband Sharing Gateway
10-9