Lan Setup; Figure 2-12 Menu 3 - Lan Setup; Table 2-7 Wan Setup Menu Fields - ZyXEL Communications Prestige 310 User Manual

FIELD
MAC Address
Assigned By Press the [SPACE BAR] to choose one of two methods to assign a
MAC Address. Choose Factory default to select the factory assigned
default MAC Address. Choose IP Address attached on LAN to use
the MAC Address of that workstation whose IP you give in the
following field.
IP Address This field is applicable only if you choose the IP Address attached
on LAN method in the Assigned By field above. Enter the IP
address of the workstation on the LAN whose MAC you are cloning.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
Your Prestige WAN Port is always set at half-duplex mode as most cable modems only support half-duplex
mode. If your cable modem supports full-duplex mode, then you will be able to manually set it at half-duplex
mode. If the Prestige is set at half-duplex mode and the cable modem is set at full-duplex mode, then the
WAN port will not function properly.
Your Prestige supports full duplex mode on the LAN side.
2.9

LAN Setup

This section describes how to configure the LAN using Menu 3 — LAN Setup. From the main menu, enter
3 to display menu 3 (shown next).
Hardware Installation and Initial Setup

Table 2-7 WAN Setup Menu Fields

DESCRIPTION
Menu 3 - LAN Setup
1. LAN Port Filter Setup
2. TCP/IP and DHCP Setup
Enter Menu Selection Number:
Figure 2-12 Menu 3 — LAN Setup
Prestige 310 Broadband Sharing Gateway
EXAMPLE
IP Address
attached on
LAN
192.168.1.33
2-15