Backup Via Console Port; Figure 10-3 System Maintenance - Backup Configuration; Figure 10-4 System Maintenance - Starting Xmodem Download Screen; Table 10-3 General Commands For Third Party Tftp Clients - ZyXEL Communications Prestige 310 User Manual

Prestige 310 Broadband Sharing Gateway

Table 10-3 General Commands for Third Party TFTP Clients

COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort
Refer to the TFTP and FTP over WAN section to read about configurations that disallow TFTP and FTP to
work over WAN.

10.2.5 Backup Via Console Port

Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.5 and enter "y" at the following screen.
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
Figure 10-3 System Maintenance — Backup Configuration
Step 2. The following screen indicates that the Xmodem download has started.
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...
Figure 10-4 System Maintenance — Starting Xmodem Download Screen
Step 3.
Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the
following screen.
10-6
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's
default IP address when shipped.
Use "Send" to upload the file to the Prestige and "Fetch" to back up
the file on your computer.
Enter the path and name of the firmware file (*.bin extension) or
configuration file (*.rom extension) on your computer.
This is the filename on the Prestige. The filename for the firmware is
"ras" and for the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
DESCRIPTION
Firmware and Configuration Maintenance