Remote Node Filter; Figure 4-3 Remote Node Filter - ZyXEL Communications Prestige 100L User Manual

4.3

Remote Node Filter

Move the cursor to the field Edit Filter Sets in Menu 11.1, then press [space bar] to toggle and set the
value to Yes. Press the [Enter] key to open Menu 11.5 – Remote Node Filter.
Use Menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige and to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by a comma, e.g., 1, 5, 9, 12, in each filter field. The default is no filters.
Note that spaces are accepted in this field.
Remote Node Setup
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Figure 4-3 Remote Node Filter
Prestige 100L IDSL Router
4-7