Figure 4-4 Menu 11.5 - Remote Node Filter - ZyXEL Communications Prestige 642 User Manual

Prestige 642 ADSL Internet Access Router
4.1.5 Remote Node Filter
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige. You can specify up to 4 filter sets separated by comma,
e.g., 1, 5, 9, 12, in each filter field. The default is no filters.
Note that spaces are accepted in this field. For more information on defining the filters, see the Filter
Configuration chapter. Note that there are two versions of this menu depending on whether you use PPPoE
encapsulation or not. When using PPPoE encapsulation, you can also specify remote node call filter sets.
Figure 4-5
4-6
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 3
device filters=
Output Filter Sets:
protocol filters= 1
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Figure 4-4 Menu 11.5 – Remote Node Filter
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 3
device filters=
Output Filter Sets:
protocol filters= 1
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Remote Node Filter (PPPoE Encapsulation)
Remote Node Configuration